Symbols On The Screen - Haskel Q-Drive QGD Series Installation, Operation And Maintenance Manual

Q-Drive Installation, Operation, and Maintenance Manual

Symbols on the Screen

Symbol Definition
Banner reports status:
Running = pumping and compression in process
Off Ready = Pump is in Stop condition and ready to be started.
Off Not Ready = there is an active alarm, refer to your alarms.
Operator CPM Limit = Operator is in control of Cycle Rate.
The Start button is not displayed until you log into the system.
While the system is running, the Start button is illuminated
green.
The Stop button is on every screen.
Status indicator for pump.
Status indicator for the mode of operation. Compressor Mode
is the most common mode. Other modes are "Fill & Pause"
and "Fill & Stop."
Status indicator for whether gas is in the system.
Status indicator for gas temperature. When the temperature is
too high, the indicator changes to High Gas Temp and flashes
red.
Home button is on every screen.
Displays the Settings screen.
Alarm button displays the Active Alarm screen.
Up and down arrows scroll the alarm log.
Logs out the current account while the system continues to
run. To make changes, tap the Locked button to log in again.
9 of 59