Table of Contents
Advertisement
Q-Drive Installation, Operation, and Maintenance Manual
Replacement Procedures
WARNING: Use a lockout procedure for power and start controls.
CAUTION: Only trained and authorized personnel can service the machine. Before
servicing, follow your site's approved lock-out procedures.
CAUTION: Never change or defeat the function of electrical interlocks or other
machine shutdown switches.
Replacing Cooling Jackets
Replacing the Piston Seals
1. Replacing Oil Filter and OilWipe away any spills and check for oil leaks.
2. Go to the Service page and tap Reset Count to restart the count at zero.
Re-Assembling Drive Rod Assembly
Tools:
Gland Wrench and Spanner
Test and transport plate
Loctite 7471
Loctite 243
FML-2 Lubricant
1. Install End Cap Insert, Seal Housing, and Guide Bush into the End Cap. At this point O-rings and
seals don't need to be installed as they are just used to home the Actuator. Gland Wrench and
Spanner.
2. Assemble the test and transport plate to seat seal housing. Assemble using 6/off M12x1.25x35
SHCS.
38 of 59
Advertisement
Table of Contents
