Firmware Upload - Wiznet WIZ200WEB User Manual

'Enable DHCP mode' at the 'board list'. If you click "Setting" button, the board acquires IP and
Subnet Mask by using DHCP. (By acquiring IP address from DHCP server, it can take some time)
After acquiring network information from DHCP, re-booting is processed. If you click "Search"
button again, you can check changed values. If you click MAC Address on the 'Board list', IP
Address, Subnet Mask and Gateway information are displayed. If network information is not
acquired due to any problem, IP, Subnet and Gateway Address are initialized to 0.0.0.0.
ⓗ Search : "Search" function is used for searching module on the same LAN. If all the modules
on the same subnet are searched by using UDP broadcast, their MAC addresses are displayed on
the "Board List".
ⓘ Setting
This function is used for changing the configuration values of WIZ200WEB. After changing any
configuration value, "Setting" button should be clicked for applying the value. With this, the values
can be saved in the EEPROM and maintained even after shutting down the power of module.
The process is as below.
① Select a MAC address at the "Board list". The configuration values of selected module are
displayed in each field.
② Change the value of each field.
③ If you click "Setting" button, the configuration is completed.
④ The module is initialized with the changed configuration. (automatically re-booted)
⑤ In order to check changed value, search the module with "Search" button.
ⓙ Upload
Firmware is uploaded through network.
Firmware upload process is described in detail at the "4.1.2 Firmware Upload"
☞ The initialization takes about 20~30 seconds after uploading the firmware.
ⓚ Exit : It closes Configuration tool program.

4.1.2. Firmware Upload

① Execute Configuration Tool program and click 'Search' button.
② If the module is correctly connected to the network, its MAC address is displayed on the
'Board list'.
© Copyright 2007 WIZnet Inc. All rights reserved
WIZ200WEB User's Manual
17