Removing The Freezer Shelves; Using The Automatic Ice Maker; Retrait Des Clayettes Du Congélateur; Utilisation De La Machine À Glaçons Automatique - Whirlpool TS22AQXGN00 Use And Care Manual

Estate by whirlpool side by side refrigerator use & care guide
Table of Contents

Advertisement

R
EMOVING THE
FREEZER SHELVES
To remove a shelf:
1.
Lift right side of shelf off supports.
2.
Slide shelf out of shelf support
holes.
3.
Replace in reverse order.
U
SING THE AUTOMATIC
ICE MAKER
Before you turn the ice maker on,
be sure that it is attached to a water
supply. Instructions for the ice maker
water supply hookup are in the
"Attaching the ice maker to a water
supply" section.
The ON/OFF lever is a wire signal
arm. Push the arm down to start
making ice automatically, and push
it up to shut off the ice maker.
It is normal for the ice to be at-
tached at the corners. It will break
apart easily.
The ice maker will not operate until
the freezer is cold enough to make
ice. This can take as long as
24 hours.
REMEMBER:
The quality of your ice will be only
as good as the quality of the water
supply that the ice maker is hooked
up to.
Signal arm
Bras de
commande
Arrêt
Off
Marche
On
R
ETRAIT DES CLAYETTES
DU CONGÉLATEUR
Pour enlever la clayette :
1.
Soulever le côté droit hors des
supports.
2.
Faire glisser la clayette vers
l'extérieur au-dessus des orifices
des supports.
3.
Replacer la clayette en suivant
l'ordre inverse.
U
TILISATION DE LA
MACHINE À GLAÇONS
AUTOMATIQUE
Avant de mettre en marche la ma-
chine à glaçons, s'assurer qu'elle est
raccordée à un conduit d'eau. Des
instructions pour le raccordement
de la machine à glaçons à la source
d'eau sont données à la section
"Raccordement de la machine à la
glaçons à une canalisation d'eau."
Le levier ON/OFF (marche/arrêt) est
un bras de commande en broche.
Abaisser le bras pour commencer
automatiquement la fabrication de
glaçons, et lever le bras pour
arrêter la fabrication de glaçons.
Il est normal que des glaçons se
collent aux coins. Ils se sépareront
facilement.
La machine à glaçons ne fonction-
nera pas avant que le congélateur
ne soit assez froid pour fabriquer
des glaçons. Ce délai peut
demander jusqu'à 24 heures.
À NOTER :
La bonne qualité de vos glaçons
dépendra de la bonne qualité de
l'approvisionnement d'eau auquel
est raccordée la machine à
glaçons.
RM
29

Advertisement

Table of Contents
loading

Table of Contents