Step 4 — Install Screws; Step 5 — Align Brackets With Screws; Step 6 — Adjust And Fasten - Extron electronics MBU 149 Setup Manual

Setup Guide — MBU 149, cont'd
Step 4 — Install screws
Insert the wood screws (provided) into the pilot holes. Fasten each screw into the furniture or
wall until the screw heads protrude slightly less than ¼" (6 mm) from the mounting surface.
Step 5 — Align brackets with screws
Align the screws with the slots in the mounting brackets and place the device against the
surface, with the screw heads through the bracket slots.
Step 6 — Adjust and fasten
Slide the device slightly forward or back, then tighten all screws to fasten it to the furniture or
wall, as shown on the right side of the diagram on the front of this guide.
Extron USA - West Extron USA - East
Headquarters
+800.633.9876
+800.633.9876 Inside USA / Canada Only
Inside USA / Canada Only
+1.919.863.1794
+1.714.491.1500 +1.919.863.1797 FAX
+1.714.491.1517 FAX
Extron Europe Extron Asia
+800.3987.6673 +800.7339.8766
Inside Europe Only Inside Asia Only
+31.33.453.4040 +65.6383.4400
+31.33.453.4050 FAX +65.6383.4664 FAX
© 2009 Extron Electronics. All rights reserved.
Extron Japan Extron China
+81.3.3511.7655 +400.883.1568
+81.3.3511.7656 FAX Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
68-704-01
Rev. B
09 09