Avalue Technology EMX-BYT2 User Manual page 65

Flow Control
VT-UTF8 Combo Key Support
Recorder Mode
Resolution 100x31
Legacy OS Redirection
Resolution
Putty KeyPad
Redirection After BIOS POST
None[Default]
Hardware RTS/CTS
Disabled
Enabled[Default]
Disabled[Default]
Enabled
Disabled[Default]
Enabled
80x24[Default]
80x25
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Always Enable[Default]
BootLoader
Communication with slow devices may
require more than 1 stop bit.
Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be
sent to re-start the flow. Hardware flow
control uses two wires to send start/stop
signals.
Enable VT-UTF8 Combination Key Support
for ANSI/VT100 terminals.
With this mode enabled only text will be
sent. This is to capture Terminal data.
Enables or disables extended terminal
resolution.
On Legacy OS, the Number of Rows and
Columns supported redirection.
Select FunctionKey and KeyPad on Putty.
The Settings specify if BootLoader is
selected then Legacy console redirection is
disabled before booting to Legacy OS.
Default value is Always Enable which
means Legacy console Redirection is
enabled for Legacy OS.
EMX-BYT2 User's Manual 65
User's Manual