Operation Instruction - Yard force YF2200LC Operator's Manual

ASSEMBLY AND OPERATION INSTRUCTIONS
OPERATION INSTRUCTIONS
WARNING
Risk of injury, Do Not Direct discharge stream at self or other persons.
WARNING
Before cleaning any surface, an inconspicuous area should be cleaned to test spray pattern
and distance for maximum cleaning results.
Fig. 16
1.Turn ON the pressure washer by pressing the button with mark " I ". The unit will run for a few seconds to
build up pressure, then will stop on the function of total stop system (TSS). (Fig. 16)
2.Release the trigger lock and squeeze the gun trigger until there is a steady stream of water. Change the
spray tip as per the recommendation above if necessary. Before changing spray tip, switch the machine
OFF, depress trigger to release pressure and engage the trigger lock. (Fig. 17)
CAUTION
Make sure spray tip and wand is well locked. Do not remove the spray tip while trigger is
depressed.
CAUTION
If painted surfaces are peeling or chipping, use extreme caution as pressure washer may
remove the loose paint from the surface.
For most cleaning applications, a twenty-five degree (25o) spray angle is recommended to
avoid damage to the surface being sprayed.
The pressure of spray on the surface will increase when you move the wand closer to the
surface.
Fig. 18
Fig. 17
13