Yard force YF2200LC Operator's Manual page 19

Pump is noisy.
Water leaks from pump
(up to 10 drops per
minute is permissible).
Oil is dripping.
Motor buzzes but fails
to run.
No water.
If you have any questions, visit our website for key FAQ's, downloadable troubleshooting steps,
instructional videos, and replacement parts purchase at www. ForceToolsUSA.com, or call our toll free hot
line: 1-(866) 902-9690.
TROUBLE SHOOTING
Pump is sucking air.
Water filter is clogged.
Loose fittings.
Water seals are damaged or worn.
Oil seals are damaged or worn.
Supply voltage below minimum.
System has residual pressure.
Voltage loss due to extension cord.
Pressure washer not used for long
periods.
Residual friction among components.
Unit might hum.
Water supply is OFF.
Kink in the garden hose.
Check that hoses and fittings are airtight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Remove water filter and rinse in warm
water.
Check that all fittings are tight.
Call the Toll-Free Hot line.
Call the Toll-Free Hot line.
Verify that only the pressure washer is
running on this circuit.
Turn unit OFF, squeeze trigger on spray
wand to release pressure, then turn unit
ON.
Unplug any extension cords attached and
plug the unit directly into the outlet.
Call the Toll-Free Hot line.
Disconnect water supply and power ON
for 2 to 3 seconds, repeat couple times or
until the motor starts.
Turn ON water supply.
Remove kink in garden hose.
19