Grandstream Networks HandyTone HT286 Product Related Questions page 3

9. Disconnect your PC from the LAN port and connect it to any other port on your Router
within the same LAN Segment
10. Type in the actual IP ADDRESS of the HT (You can look this up by pressing *** on the
phone, and then 02) on Internet browser, access the Web Configuration page as you did earlier
and configure the device by filling in the information given by your Internet Telephony Service
Provider (ITSP).
Q: How do I setup a 3-way conference call?
Setting up a 3-way conference calling between parties using an HT, A and B is easy:
1. HT calls A
2. HT talks to A
3. HT presses FLASH or hook/flash and gets a new dialtone
4. A is on Hold
5. HT dials *23 and number for B
6. HT talks to B
7. HT presses FLASH or hook/flash to initiate the 3-way calling
Q: How do I perform attend transfer?
Attend Transfer from A to B through HT:
1. A calls HT
2. HT talks to A
3. HT presses FLASH or does hook/flash to get new dialtone.
4. A is on Hold
5. HT calls B
6. HT talks to B
7. HT hangs up to perform the Attend Transfer.
8. A and B are in call now.
Q: Which phone will ring if there is an incoming call on my wire (fixed) line (HT386)?
The Phone connected to FXS1 port will ring when there is an incoming call on the Fixed Line.
Q: How do I make or receive PSTN calls on my HT (for HT486/386/488)?
When receiving a call, the phone connected to the HT simply rings. When placing a call, dial the
'PSTN Line Access Code' first, as configured on the Web Configuration Page (by default it is
*00), and then dial the desired PSTN number.