Advertisement
P/N 3124450_A
INSTALLING CONDENSING UNIT SOUND BARRIER
The condensing unit sound barrier is installed to reduce noise generated by the refrigeration system. Bracket
supports are attached to the top of the case(s). The Sound panel fits over the condensing unit and is attached to
the brackets with screws.
Bracket attaches to top of case to
retain front edge of Sound Panel.
Secure with supplied Fasteners.
Attach Bracket Support to
Condenser Mounting
Bracket using #8 Screws.
(Mounting Plate has
pre-punched Pilot Holes.)
Installing Balloon Guard.
The balloon guard is to prevent
inflated balloons from coming
into contact with the coils. Attach
brackets and balloon guard near
inlet coil as shown.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Bracket attaches to top of case
to retain front edge of Sound
Panel. Secure with supplied
Fasteners.
Cover Bracket (2
Places) attach to top of
Case using #8 Sheet
Metal Screws provided
(2 Places) each Bracket.
B
DETAIL A
Attach Plastic
Mesh Balloon
Guard to Bracket
and top of case.
Sound Panel
On Cases where the Condensing Unit extends beyond
back of case(s), use Bracket Support provided. Attach
Bracket to Support to retain Sound Panel in place.
Place Edges of Sound Panel
into Bracket. Secure 2 places
with provided Push Rivets.
DETAIL B
Install Balloon Guard
A
NOTE: Taller side of
Bracket to Inside
Attach Bracket to top of Case
near Air Inlet side of Coil.
Freedom Reach-in
13
Advertisement
