Service Diagnostics; Entering Diagnostic Mode - Kenmore 106.89592100 Technical Education

Service Diagnostics

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
When performing live voltage measurements, you must do the following:
Verify the controls are in the off position so that the appliance does not start when energized.
Keep other people a safe distance away from the appliance to prevent potential injury.
IMPORTANT: Always used the Technical Data Sheet shipped with the product. The tech sheet information
depicted in this Job Aid is an example only.

ENTERINg dIAgNOsTIc MOdE

Entering and using the diagnostic
routine takes a little practice to
become familiar with the process.
Utilize watt meter during
diagnostics
Make sure to press CLEAN then
ON – but not both at same time.
Both the Clean and On buttons
must be activated together. Press
and hold the clean button first
and then press and hold the On
button.
Voltage measurement safety information
DIAGNOSTICS & TROUBLESHOOTING
DANGER
Electrical Shock Hazard
Only authorized technicians should perform
diagnostic voltage measurements.
After performing voltage measurements,
disconnect power before servicing.
Failure to follow these instructions can result in
death or electrical shock.
n 5-3