Drain Pump Installation; If Ice Maker Is Currently Installed; Rear View; Kit Contents - Kenmore 106.89592100 Technical Education

INSTALLATION ANd OperATINg INSTrucTIONS
A B C
I
I
I
⁵⁄₈ ¹⁄₈
I
n
2-8
A
B
C
Ice Production
D
PROBLEM
Ice Maker Runs But Produces
No Ice
Ice Maker Runs But Produces
Very Little Ice
Ice Quality
PROBLEM
¹⁄₂
I
⁵⁄₁₆
I
I
³⁄₈
I
⁵⁄₈
I
⁷⁄₈
I
I
I
WARNING
WARNING
Electrical Shock Hazard
Electrical Shock Hazard
Disconnect power before servicing.
Disconnect power before servicing.
Replace all parts and panels before operating.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Failure to do so can result in death or electrical shock.
RECOMMENDED SOLUTIONS
Check that the control is turned on.
Check that the water supply is properly connected and turned on.
If the drain cap is loose, water will empty from the water pan, and you will have ei
the drain cap.
Clean the drain tube.
Check that there are no kinks in the drain line.
If the accelerated ice production feature is turned on, this feature increases the ic
you with more ice in the same amount of time.
Room temperatures of more than 90°F (32°C) will normally reduce ice production
Dirt or lint may be blocking the airflow through the condenser.
A
If there is white scale buildup in the ice maker's water or freezing system, you sho
If the drain cap is loose, water will empty from the water pan, and you will have ei
the drain cap.
Ensure that the cutter grid is securely in place and that its harness plug is connec
Check that water filter is properly installed.
RECOMMENDED SOLUTIONS