COMPONENT ACCESS
Ice Bin Components (cont.)
rEmOviNg rEcircuLaTiON pump
12. Remove the harness connection. Release the pump
retainer. Press out the pump.
NOTE: The pump operates on 12 VAC. Resistance is 3.6
OHMS. See Figure 16.
4-6
n
FIGURE 16
rEmOviNg waTEr LEvEL sENsOr
13. Disengage the water level switch from the housing.
Remove the wire harness connector.
NOTE: The water level sensor cannot be checked with a
meter - use the diagnostic program step #10. See Figure 17.
rEmOviNg draiN pump
14. Remove screw and pump.
NOTE: It's normal for the impeller and stator to separate
when removed. If the pump is going to be reassembled for
use – check the seals. See Figure 18.
Notes
FIGURE 17
FIGURE 18