Accessing Ice Bin Electrical Connections; Removing Reservoir And Pumps - Kenmore 106.89592100 Technical Education

Ice Bin Components (cont.)

accEssiNg icE BiN ELEcTricaL cONNEcTiONs

8. Remove the water tube from the left side of the cover
and roll cover up and out. See Figure 12.
9. Remove wire harnesses. See Figure 13.
NOTE: If one of the pumps is not functioning during the
diagnostic check a resistance reading can be made.
Approximately 3.6 OHMS of resistance should be measured
across the recirculation pump and the drain pump.
If a pump checks good but did not operate during the
diagnostic test – make sure all the connections are tight
and retry the operation before replacing the pump.
FIGURE 12
FIGURE 13

rEmOviNg rEsErvOir aNd pumps

10. Remove 1 hex head screw and remove the reservoir
assembly. Remove wire harness. See Figure 14.
11. Use a pair of pliers to remove christmas tree retainers.
See Figure 15.
COMPONENT ACCESS
FIGURE 14
FIGURE 15
4-5
n