Download Print this page

Ice Maker Top Components - Kenmore 106.89592100 Technical Education

15” under counter ice makers with filter
Hide thumbs

Advertisement

Table of Contents

Ice Maker Top Components

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
rEmOviNg TOp
1. Unplug ice maker or disconnect power.
NOTE: To access control board, UI board, transformer or
water level switch, the top must be removed. To remove the
top, the swing door must be removed first. See Installation
Instructions on Page 2-9.
2. Begin by removing the 2 Phillips head screws in the top
front of the machine. See Figure 19.
FIGURE 19
3. Remove the 2 hex head screws located in the back of
the unit. Raise the top.
NOTE: Lay a board across the cabinet under the top and
then cover with a protective blanket. The board and blanket
are needed to provide a working area when the control
compartment is separated from the top. See Figure 20.
4. Unsnap water tube on the reservoir cover. Disconnect
the wire harness plugged into the right side of the control
housing. See Figure 21.
COMPONENT ACCESS
FIGURE 20
FIGURE 21
4-7
n

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

106.89599100106.89593100106.89553100