Accessing The Control Compartment; Removing Transformer; Removing User Interface Board - Kenmore 106.89592100 Technical Education

COMPONENT ACCESS
Ice Maker Top Components (cont.)

accEssiNg ThE cONTrOL cOmparTmENT

NOTE: This procedure will prove challenging the first time
attempted.
5. 5 hex head screws will need to be removed while
supporting the top. Grasp the center of the top with left
hand to support top. Screw # 5 needs to be the last to
be removed. When the last screw is removed the control
housing will separate from the top. See Figure 22.
6. Lay the control housing on the board and blanket
previously positioned. While supporting top remove the
ground wire. See Figure 23.
4-8
n
FIGURE 22
FIGURE 23

rEmOviNg TraNsfOrmEr

7. Remove 2 screws and connectors.
NOTE: The transformer doesn't have to be removed to
make voltage and resistance checks. See Figure 24.

rEmOviNg usEr iNTErfacE BOard

8. Release retainers to remove UI board. See Figure 25.
FIGURE 24
FIGURE 25