Drain Pump Mounting Tab Slot; Drain Pump Installed; Vent Tube - Kenmore 106.89592100 Technical Education

INSTALLATION ANd OperATINg INSTrucTIONS
³⁄₈
³⁄₈
n
2-10
A
Problem Solver
Scan the code at left with your mobile device, or visit https://jennair.custhel
recommendations that may help you avoid a service call.
A
Ice Maker Operation
⁵⁄₈
PROBLEM
Ice Maker Will Not Operate
Ice Maker Seems Noisy
A
B
¹⁄₂
⁷⁄₈
Electrical Shock Hazard
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not remove ground prong.
Do not use an adapter.
Do not use an adapter.
Do not use an extension cord.
Do not use an extension cord.
Failure to follow these instructions can result in death,
Failure to follow these instructions can result in death,
fire, or electrical shock.
fire, or electrical shock.
RECOMMENDED SOLUTIONS
Check that it is plugged into a grounded 3 prong outlet.
Check that the control is turned on.
Replace the fuse or reset the circuit breaker.
NOTE: If problems continue, contact an electrician.
Room temperature must be above 55°F (13°C). Otherwise, bin thermostat may se
and shut off even though the bin is not full of ice. The ice maker may not restart o
If there was a large amount of water added to the ice maker, wait a few minutes fo
there is still water in the bin, check to see whether the drain hose is kinked.
For models with drain pumps, check that the drain hose is not damaged, or kinked
and ice maker. Use only Whirlpool approved drain pump kit, Part Number 1901A.
Water overflowing the reservoir is normal. This overflow helps to purge minerals t
WARNING
WARNING