Adjusting The Crisper Humidity Control; Adjusting Meat Drawer Temperature; Adjusting The Refrigerator Shelves; Removing Crispers, Meat Drawer And Covers - Whirlpool ED25DW Use & Care Manual

Adjusting the crisper humidity control
.
You can control the amount of humidity in the
moisture-sealed crisper.
1.
The control can be adjusted to any setting
between LOW and HIGH.
/
2. LOW [open] lets moist air out of crisper for best
storage of fruits and vegetables with skins.
'
3. HIGH (closed) keeps moist air in the crisper for
best storage of fresh leafy vegetables.
Adjusting meat drawer temperature...
USE CONTROL TO ADJUST
MEAT DRAWER TEMPERATURE
Adjusting the refrigerator shelves...
SPILLGUARD shelves can be adjusted to match the
way you use your refrigerator. Glass shelves are
strong enough to hold bottles, milk and other
heavy food items.
GLASS SHELVES ARE
HEAVY. BE CAREFUL.
Cold air flows against the meat drawer through
an opening between the freezer and the refrigera-
tor. This helps keep the meat drawer colder than
the rest of the refrigerator.
Setthe control to let more or less cold airthrough.
To remove glass shelves:
1.
Lift up front.
2. Slide shelf out with an even, constant pull to the
stop, lift front and slide the rest of the way out.
To replace glass shelves:
1.
Guide rear of shelf into shelf guide.
2. Slide shelf in with an even, constant motion to the
stop, lift front and slide the rest of the way in.
To move shelf guides:
1. Remove shelf.
2. Lift front of guide, pull guide off rear support.
Repeat for other guide.
3. Replace in reverse order.
Removing the crispers, meat drawer and covers...
To remove the crispers and meat drawer:
1.
Slide crispers and meat drawer straight out to
the stop. Lift the front, then slide the rest of the
way out.
2. Replace in reverse order.
PULL OUT TO THE STOP
LIFT THE FRONT
AND PULL AGAIN.
To remove the covers:
1.
Lift front of cover off supports.
2. Lift out cover by pulling up and out.
To replace the covers:
l
Fit back of cover in notch supports on walls of
refrigerator, then lower into place.
NOTE: Glass cover will fit only above full width
crisper.
LIFT THE COVER FRONT, \
THEN THE BACK.
GLASS IS HEAVY,
BE CAREFUL.
6