Removing The Crispers And Crisper Cover; Adjusting The Crisper Humidity Control; Removing The Freezer Shelf - Whirlpool 22’ TO 25’ NO-FROST DESIGNERSTYLE TOP FREEZER REFRIGERATOR WITH THIRSTCRUSHERDISPENSING SYSTEM Use & Care Manual

Removing the crispers and crisper cover
To remove the crispers:
1.
Slide crisper straight out to the stop.
2. Lift the front and slide out the rest of the way.
3. Replace in reverse order.
To remove the cover:
1.
Push up the glass insert from the bottom, then slide
out with both hands.
2. Lift front of cover frame.
3. Lift cover frame up and out.
To replace the cover:
1.
Fit back of cover frame into notch supports on back
wall of refrigerator, then lower the front into place.
2. Make sure the front cover metal support is in the
notches in the sides of the liner.
NOTE:
If the support is not positioned properly, the
doors may not close all the way.
3. Slide back of glass insert into place, then lower front.
Pull out to the stop, lltt
the front, and pull again.
Remove the glass insert.
Lift the cover front, then
the back.
NOTE: Glass Insert Is ,
heavy. Handle It carefully.
Adjusting the crisper humidity control
You can control the amount of humidity in the
moisture-sealed crispers. Adjust the control to any
setting between LOW and HIGH.
l
LOW (open) lets moist air out of the crisper for best
storage of fruits and vegetables with skins.
l
HIGH (closed) keeps moist air in the crisper for best
storage of fresh, leafy vegetables.
Humidity Control
HlCH.*.~*LOW -
Removing the freezer shelf
To remove the shelf:
1.
Lift right side of shelf off supports.
2. Slide shelf out of shelf support holes,
3. Replace in reverse order.
12