Removing The Crispers And Crisper Cover; Adjusting The Crisper Humidity Control; Adjusting The Half-Width Freezer Shelf - Whirlpool ET22DKXDB00 Use And Care Manual

Removing the crispers and crisper cover
To remove
the crispers:
I.
Slide crisper straight out to the stop.
2. Lii the front and slide out the rest of the way.
3. Replace in reverse order.
To
remove the cover:
1. Push up the glass insert from the bottom, then slide
out with both hands.
2. Lii front of cover frame.
3. Lift cover frame up and out.
To replace the cover:
1.
Pit back of cover frame into notch supports on back
wall of refrigerator, then lower the front into place.
2. Make sure the front cover metal support is in the
notches in the sides of the liner.
NOTE: If the support is not positioned properly, the
doors may not close all the way.
3. Slide back of glass insert into place, then lower front.
Pull out to the stop, ill
the front, and pull again.
Remove the glaea insert.
Lift the cover front, then
the back
NOTE: Glass lnrert ie
heavy. Handle it carefully.
Adjusting the crisper humidity control
You can control the amount of humidity in the rnoisture-
sealed crispers. Adjust the control to any setting
between LOW
and
HIGH.
l
LOW (open) lets moist air out of the crisper for best
storage of fruits and vegetables with skins.
l
HIGH (closed) keeps moist air in the crisper for best
storage of fresh, leafy vegetables.
Adjusting the half-width freezer shelf
Adjust the shelf according to the space you need in
your freezer. Use the bottom position when you don't
need the shelf at all.
To adjust the shelf:
1.
Remove items from the shelf.
2. Lii shelf up at front.
3. Pull shelf out to the stop.
4. Lii back of shelf.
5. Pull shelf out the rest of the way.
To replace the shelf:
1.
Guide rear of shelf into desired guide.
2. Lift rear of shelf over stop.
3. Slide shelf in all the way.
4. Lower front into place.
11