Table of Contents
Advertisement
Before using your
refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any
inside
labels before using the refrigera-
tor.
To remove
any remaining
glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
de-
tergent before removing glue as described
in
step 1.
DO NOT USE rubbing
alcohol
or flammable
or
toxic
solvents,
such as acetone,
gasoline,
car-
bon tetrachloride,
etc. These can damage
the
material.
NOTE: DO NOT REMOVE ANY PERMANENT
IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove
the Tech sheet fastened
under
the refrigerator
at the front.
2. Clean it...
Clean
your refrigerator
before
using it. See
cleaning
instructions on page 8.
3. Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRlGERAiOR
3-PRONG
POWER CORD
GROUNDING PLUG
RECOMMENDED
GROUNDING
METHOD
A 115 Volt. 60 Hz., AC only 15 or 20 ampere fused
and properly
grounded
electrical
supply is re-
quired. It is recommended
that a separate circuit
serving only this appliance
be provided.
Do not use an extension
cord.
Use a recepta-
cle which
cannot
be turned
off with a switch
or
pull chain.
See individual
electrical
requirements
and grounding
instruction sheet in your literature
package.
4. Install properly...
/
1L
lIri-lII
I I
1.
Allow Y2 inch (1.25 cm) space on each side and
at the top of the refrigerator
for ease of
installation.
2. If the refrigerator
is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
4. Make sure ice maker water supply has been
connected.
Refer to Installation Instructions.
5. Level re'frigerator-freezer...
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
1.
Remove base grille (see page 8).
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4.
Check with level.
5. Replace base grille (see page 8).
4
Advertisement
Table of Contents
