Ice Cube Trays .,I; Optional Automatic Ice Maker; Changing Light Bulbs; Removing The Base Grille - Whirlpool ED22MK Use & Care Manual

Ice cube trays...
To remove ice:
l
Hold tray at both ends.
. Slightly twist
If cubes are not used, they may shrink The movtng
cold air starts a slow evaporation The longer cubes
are stored, the smaller they get
Optional automatic ice maker...
d&e Signal
Arm to Stop Ice Maker
lower Signal
Arm to Start It
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-6). there are
a few things you will want to know:
l
The ON /OFF lever is a wire signal arm.
Down., .for making Ice automutically:
Up,, to shut off the ice 'maker.
l
Shake the bin occaslonally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You'll hear ice fall into the bin Don't let
these sounds bother you.
l
The ice maker WIII not operate until the freezer is
cold enough to make ice. This can toke overnight.
l
Because of new plumbing connections, the first
ice may be dlscolored or off-flavored Discard the
first few batches of Ice.
l
If Ice
IS
not being made fast enough and more Ice
is needed, turn the Temperature control to a higher
number. Wait a day and, If necessary. turn the Air
Control to a higher number
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
positlon.
l
If cubes are stored too long, they may develop an
off -flavor like stale water. Throw them away. They
WIII be replaced. Cubes in the ice bin can also
become smaller by evaporation
Changing light bulbs...
Before removing a light shield for cleaning or for
replacing a bulb, unplug the retrigerator. Use
up-
plmnce bulbs only
Pull Off the
Pull Out at the
Ught bulbs behind refrigerator and freezer
control consoles:
- Pull control knob straight off.
- Pull bottom of control panel straight out.
-Lift top of panel off supports.
- Replace with a 40.watt appliance bulb.
- Replace panel In reverse order.
l
Light bulb behind crispers:
l
Remove crispers and crisper covers.
l
Bulb is on back wall of refrigerator.
l
Replace with a 40-watt appliance bulb.
l
Replace crisper and crisper cover.
l
Plug in the refrigerator.
Removing the base grille...
l
Open the doors.
l
Pull grille outwards as shown.
l
Do not remove Tech sheet fastened behind grille
Support Tabs
To replace:
l
Line up grille support tabs with metal clips
l
Push firmly to snap into place.
l
Close the doors.