Table of Contents
Advertisement
Using
the ice cube trays
If you don't use the cubes, they may shrink.
The moving cold air starts a slow evapora-
tion. The longer you store cubes, the smaller
they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using
the automatic
ice maker
(optional
accessory
on some
models)
If you have an automatic ice maker, or if you
plan to add one later (contact dealer for ice
maker kii number), there are a few things
you will want to know:
l
For some models: The aluminum water
inlet tube, supplied with your refrigerator, is
in the rear bottom of the refrigerator, on
the compressor support plate. Use this
tube instead of the tube provided in the
accessory kit.
l
The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn ice maker on
until it is connected to the water supply.
Instructions
for ice maker water supply
hookup are attached to the back of the
refrigerator cabinet.
l
If you remove the ice bin, raise the signal
arm to the OFF position. When you
replace the bin, push it all the way in and
lower the signal arm to the ON position.
l
Good water quality is important for good
ice quality. Try to avoid connecting the ice
maker to a softened water supply. Water
softener chemicals. such as salt from a
malfunctioning softener, can damage the
ice maker mold and lead to poor ice
quality. lf a softened water supply cannot
be avoided, make sure that the water
softener is well maintained and operating
PropeW.
start ice (
maker.
11
Advertisement
Table of Contents
