MTS Systems Exceed 40 Series Site Preparation Manual page 2

Copyright information
© 2013 MTS Systems Corporation. All rights reserved.
Trademark information
MTS is a registered trademarks and MTS Exceed is a trademark of MTS Systems
Corporation. These trademarks may be protected in other countries.
Proprietary information
Software use and license is governed by MTS' End User License Agreement
which defines all rights retained by MTS and granted to the End User. All
Software is proprietary, confidential, and owned by MTS Systems Corporation
and cannot be copied, reproduced, disassembled, decompiled, reverse
engineered, or distributed without express written consent of MTS.
Software validation and
MTS software is developed using established quality practices in accordance
verification with the requirements detailed in the ISO 9001 standards. Because MTS-
authored software is delivered in binary format, it is not user accessible. This
software will not change over time. Many releases are written to be backwards
compatible, creating another form of verification.
The status and validity of MTS' operating software is also checked during
system verification and routine calibration of MTS hardware. These controlled
calibration processes compare the final test results after statistical analysis
against the predicted response of the calibration standards. With these established
methods, MTS assures its customers that MTS products meet MTS' exacting
quality standards when initially installed and will continue to perform as intended
over time.
2 MTS Exceed™ Series 40 Site Preparation Guide