MTS Systems Exceed 40 Series Site Preparation Manual page 14

Fixture and Specimen Handling Considerations
Fixture and Specimen Handling Considerations
Telephone and Network Access
Acoustics
Temperature
Heat Dissipation
14 Site Preparation
Movement of specimens in and out of the test system must be considered early in
the planning of the site layout. With smaller specimens, the use of a rolling work
cart with storage drawers is often recommended to facilitate the handling of
specimens and to minimize the chance of damage to the specimens prior to and
after the test. As specimen size and fixturing increase beyond the typical lifting
capacity of laboratory personnel, use of an overhead crane, lifting straps, or a
forklift might be necessary to handle specimens or fixtures.
Ensure that a telephone line is located within the general testing area. This
enables the user to contact MTS' service department directly from the testing
area so the user can perform the instructions provided and resolve the situation
while on the telephone with the service representative. This facilitates resolving
issues in a timely manner and reduces the number of repeated phone calls on the
same problem.
It is also suggested that network drops, or digital phone lines, be within the
general testing area. A network connection near the system facilitates distributing
test data via the network. MTS' goal is to provide remote diagnostics in order to
resolve system issues. Having a network drop or digital phone line available will
enable an MTS service representative to dial into the test system's computer to
diagnose and resolve problems more efficiently. Including the network or digital
lines in your initial site preparation will facilitate adding this function if it
becomes necessary in the future.
Some types of testing can produce noise which is undesirable or potentially
damaging to hearing. Acoustical treatment of walls and ceiling might be
necessary to prevent harm to personnel. If disk drives are included in the system,
acoustical materials should not be of the type that generates or harbors dust.
The use of hearing protection is recommended for personnel involved in long-
term testing in a noisy testing environment.
The operating temperature range of the load frame is 5°C to 40°C (51°F to
104°F). Although the load cell or force transducer is temperature compensated, it
is recommended that room air heating and cooling outlets be directed so that they
uniformly distribute air throughout the room.
For comfortable working conditions and proper operation of the equipment, the
heat dissipation of the PC cabinet/desk and other equipment must be considered
in providing adequate heating or air conditioning to the laboratory area.
MTS Exceed™ Series 40 Site Preparation Guide