Seicane S126005 Upgrade Installation Replacement Instruction

Universal aftermarket car radio

Table of Contents

Download this manual

Seicane S126005 Universal aftermarket car radio upgrade

installation replacement instruction

Seicane S126005 Universal car stereo after installation

Before and during installation, you should notice:

1.Before connecting, please make sure the ignition is off to avoid short circuit.

2.Ensure connect the yellow and red power cable at last.

3.Ensure that all loose wires are isolated with electrical tape

4.Ensure don't tangle the wire when tighten the moving parts(Such as seat rails).

5.Ensure that all ground is connected to the same place.

6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult

the professional.

7. For your convenience, here's the recommended tools for removal and installation from

Seicane, please check for more details:

srd-400

www.seicane.com

http://www.seicane.com/car-dvd-dismantling-device-

Table of Contents

Do you have a question about the S126005 and is the answer not in the manual?

Page 1 Seicane S126005 Universal aftermarket car radio upgrade installation replacement instruction Seicane S126005 Universal car stereo after installation Before and during installation, you should notice: 1.Before connecting, please make sure the ignition is off to avoid short circuit. 2.Ensure connect the yellow and red power cable at last.
Page 2 Universal car stereo installation guide Step 1: Use a screwdriver to remove two screws above the original car radio. Step 2: Remove the trim panel. Please wedge a flat tip screwdriver under the trim panel and pry up on it to remove the trim panel.
Page 3 Step 4: Disconnect the radio antenna in the back of the factory radio and unplug the electrical plugs running to the back of the radio. Step 5: Check all the accessories for the new Seicane car radio. Step 6. Connect the harnesses to the back of the new Seicane car radio.
Page 4 Step 7. Connect the Seicane car radio to your original car radio 's plugs. Step 8: Turn on the new Seicane car stereo to have a careful check if it works well with your car. If it doesn’t, please check whether all the cables are connected correctly.