Seicane S085993 Upgrade Installation Replacement Instruction

2014 mercedes-benz vito viano aftermarket radio dvd gps stereo upgrade

www.seicane.com

Seicane S085993 2014 Mercedes-Benz vito viano aftermarket radio dvd

gps stereo upgrade installation replacement instruction

Seicane S085993 2014 Mercedes-Benz vito viano car stereo after installation

Please note:

This unit can be suitable for the following cars which are also with the same installation steps

as follows.

2014 Mercedes-Benz vito viano

Mercedes-Benz B Class W245 B150 B160 B170 B180 B200 B55 before 2011

Safety notes

1. Before connecting, please make sure the ignition is off to avoid short circuit.

2. Ensure connect the yellow and red power cable at last.

3. Ensure that all loose wires are isolated with electrical tape

4. Ensure don't tangle the wire when tighten the moving parts(Such as seat rails).

5. Ensure that all ground is connected to the same place.

6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult

the professional.

Table of Contents

Do you have a question about the S085993 and is the answer not in the manual?

Page 1 Seicane S085993 2014 Mercedes-Benz vito viano aftermarket radio dvd gps stereo upgrade installation replacement instruction Seicane S085993 2014 Mercedes-Benz vito viano car stereo after installation Please note: This unit can be suitable for the following cars which are also with the same installation steps as follows.
Page 2 2014 Mercedes-Benz vito viano car stereo installation guide 1. Detach the outer frame of the original car radio. 2. Use a screw driver to remove the screws marked with red circles. 3. Remove the screw on the lower right.
Page 3 5. Remove the screw on the upper left. 6. Remove the screw on the upper right. 7. Use a screw driver to remove the screws marked with red circles. 8. Remove the original car radio.
Page 4 9. Check all the accessories for the new Seicane car stereo. 10. Connect the harnesses to the back of the new Seicane car stereo. 11. Insert the plug of the car into the socket of unit.
Page 5 14. Fasten the new Seicane car stereo with 4 screws and install the frame back. 15. Turn on the new Seicane car stereo to have a comprehensive check. If everything works well, all the installation is done. If not, please check if all the cables are connected correctly.