Seicane S126001 Upgrade Installation Replacement Instruction

2012 geely emgrand ec7 aftermarket car stereo

Seicane S126001 2012 Geely Emgrand EC7 aftermarket car stereo

upgrade installation replacement instruction

Seicane S126001 2012 Geely Emgrand EC7 car stereo after installation

Precautions for this installation:

1.Before you start up any work, park your car well and unplug the negative power cable to avoid

any danger.

2.Please make sure that all fastened wires are isolated with electrical tape.

3.Please make sure the ignition is off to avoid short circuit.

4. For your convenience, here's the recommended tools for removal and installation from

Seicane, please check for more details:

srd-400

www.seicane.com

http://www.seicane.com/car-dvd-dismantling-device-

Table of Contents

Do you have a question about the S126001 and is the answer not in the manual?

Page 1 Seicane S126001 2012 Geely Emgrand EC7 aftermarket car stereo upgrade installation replacement instruction Seicane S126001 2012 Geely Emgrand EC7 car stereo after installation Precautions for this installation: 1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
Page 2 2012 Geely Emgrand EC7 car stereo installation guide 1·Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside. 2·Remove screws that fixed the radio on the dashboard.
Page 3 5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure. 6. Put the new Seicane car stereo into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.
Page 4 8·Firm the panel on the new Seicane car stereo. Finally the new Seicane car stereo is installed and a comprehensive test should be conducted on the new radio. Please note: We suggest you arrange a professional to install it. If you have any questions about installation,...