Seicane S127668 Upgrade Installation Replacement Instruction

2007-2011 toyota camry aftermarket car stereo head unit

www.seicane.com

Seicane S127668 2007-2011 Toyota Camry aftermarket car stereo

head unit upgrade installation replacement instruction

Seicane S127668 2007-2011 Toyota Camry car radio after installation

Before and during installation, you should notice:

1.Before connecting, please make sure the ignition is off to avoid short circuit.

2.Ensure connect the yellow and red power cable at last.

3.Ensure that all loose wires are isolated with electrical tape

4.Ensure don't tangle the wire when tighten the moving parts(Such as seat rails).

5.Ensure that all ground is connected to the same place.

6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult

the professional.

7. For your convenience, here's the recommended tools for removal and installation from

Seicane, please check for more details:

http://www.seicane.com/car-dvd-dismantling-device-srd-

400

Table of Contents

Do you have a question about the S127668 and is the answer not in the manual?

Page 1 Seicane S127668 2007-2011 Toyota Camry aftermarket car stereo head unit upgrade installation replacement instruction Seicane S127668 2007-2011 Toyota Camry car radio after installation Before and during installation, you should notice: 1.Before connecting, please make sure the ignition is off to avoid short circuit.
Page 2 2007-2011 Toyota Camry car radio installation guide 1. The original car radio. 2. Unscrew the shift knob of the parking brake. 3. Remove two side panels.
Page 3 4. Remove the bottom panels. 5. Unscrew two screws with a screwdriver.
Page 4 6. Remove the glove. 7. Disconnect the connectors at the back of the glove. 8. Remove the a/c vent with a removal tool.
Page 5 9. Disconnect the connectors at the back of the a/c vent. 10.Unscrew four screws holding the original radio in dash with a screwdriver. 11. Take the original car radio out of the dashboard.
Page 6 15. Connect the Seicane car radio to your original car radio 's plugs. 16.Turn on the new Seicane radio to have a careful check if everything works well. If it doesn't, please check whether all the cables are connected correctly.