Seicane S128007 Upgrade Installation Replacement Instruction

2013 2014 nissan x-trail qashqai aftermarket car radio

Advertisement

Seicane S128007 2013 2014 Nissan X-Trail QashQai aftermarket car
radio upgrade installation replacement instruction
Seicane S128007 2013 2014 Nissan X-Trail QashQai car radio after installation

Before and during installation, you should notice:

1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don't tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult
the professional.
7. For your convenience, here's the recommended tools for removal and installation from
Seicane, please check for more details:
srd-400
www.seicane.com
http://www.seicane.com/car-dvd-dismantling-device-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S128007 and is the answer not in the manual?

Questions and answers

Summary of Contents for Seicane S128007

  • Page 1 Seicane S128007 2013 2014 Nissan X-Trail QashQai aftermarket car radio upgrade installation replacement instruction Seicane S128007 2013 2014 Nissan X-Trail QashQai car radio after installation Before and during installation, you should notice: 1.Before connecting, please make sure the ignition is off to avoid short circuit.
  • Page 2 2013 2014 Nissan X-Trail QashQai car radio installation guide 1. Remove the right trim panel with a lever. 2. Remove the left trim panel with the same way as step 1. 3. Pry the edges of the a/c controller with a lever.
  • Page 3 4. Take the a/c controller out of the dash. 5. Unscrew all the screws holding the original car radio in place with a screwdriver. 6. Gently take the original car radio out the dash. 7. Disconnect all the connectors at the back of the original car radio.
  • Page 4 10. Connect the Seicane car radio to your original car radio 's plugs. 11.Turn on the new Seicane radio to have a careful check if everything works well. If it doesn't, please check whether all the cables are connected correctly.

Table of Contents