Advertisement
Quick Links
CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit
1
Install Software
1. Insert the CY3215A-DK CD/DVD into the
CD/DVD drive of your PC.
2. Install the kit contents, PSoC Programmer,
and PSoC Designer.
Note: After installation, follow instructions
in step 2 to debug using pod kit OR follow
the instructions in steps 3 and 4 to program
PSoC 1 based target board.
3
To Program Target Boards
1. Attach the backward compatibility
adapter to the ICE-Cube in the place
of the flex-pod.
2. Connect the RJ45 end of the ISSP
cable into the adapter.
Quick Start Guide
2
Use Pod to Debug
1. Attach the flex cable and pod to the
ICE-Cube (ICE base unit).
2. Create a project in PSoC Designer and
start debugging.
Note: Pod Kit needs to be purchased
separately. Visit
shop
to find the latest list of Pods.
4
3. Connect the 5-pin connector of the ISSP
cable to your PSoC 1 based target
board's ISSP header.
4. Program the parts using PSoC Programmer.
www.cypress.com/go/
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Cypress PSOC 1 Series
Summary of Contents for Cypress PSOC 1 Series
- Page 1 Note: After installation, follow instructions Note: Pod Kit needs to be purchased in step 2 to debug using pod kit OR follow separately. Visit www.cypress.com/go/ the instructions in steps 3 and 4 to program shop to find the latest list of Pods.
- Page 2 +1 (800) 541-4736 Ext. 8 (in the USA) or +1 (408) 943-2600 Ext. 8 (International). For the latest information about this kit, visit www.cypress.com/go/CY3215A-DK © 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-80388 Rev. **...
Need help?
Do you have a question about the PSOC 1 Series and is the answer not in the manual?
Questions and answers