5-18 DK35/40/450L
LIFTING DEVICES FOR AN ATTACHMENT
The hydraulic lifter can always be oper-
ated while the engine is running, regard-
less of engagement or disengagement of
the clutch.
POSITION CONTROL
(1) Position Control Lever
The position of an attachment can be
freely controlled within the range of po-
sition control, using the lever. An attach-
ment will completely lower when the le-
ver is in the floating range.
DRAFT CONTROL
615O520A
(1) Draft contol Lever
1. The draft control is used to do draft work
with an attachment, like a plow, attached
to the 3-point linkage.
2. In the floating range. the attachment will
completely lower.
3. In the draft control range, the hydraulic
unit will have a force to lift the attachment.
In this stage, it is possible to do stable
work without slipping.
4. If the draft force is higher than the resis-
tance of the attachment, the attachment
will be lifted up. If it is lower than the re-
sistance of the attachment, the attach-
ment will be restored to its original state.
5. By placing the lever closer to shallow, the
attachment can be lifted up by smaller draft
resistance.
615O521A