Tires; When Implement Is Not Attached; Adjustment Of Lower Link; Adjustment Of Check Link - Kioti DK35 Manual

WHEN IMPLEMENT IS NOT ATTACHED

1. Fix lower link (LH. RH) not to touch
with wheels when implement is not
attached.
2. Fix Top link into fixed bracket.
ADJUSTMENT OF TOP LINK
1. Extend or reduce Top link to adjust the
inclination of an attachment.
2. Fix Top link with fixed nut after adjust-
ing top link.
3. The position for mounting Top link var-
ies depending on the kind of attach-
ment.

ADJUSTMENT OF LOWER LINK

Implement Stabiliser adjustment
Soil engaging
Place pin in slotted hole
(plough etc)
Non-soil
Place pin in a non slotted
engaging
hole so that implement
(mower etc) cannot sway laterally.
ADJUSTMENT OF LIFT ROD
1. Adjust the length of the lift rod accord-
ing to the property of implement.
A standard length is 430 mm (16.9 in.)
from lifting arm.
2. Fasten the fixed nut after keeping the
implement from leaning by turning.
Turn buckle of the lift rod on the right
side.

ADJUSTMENT OF CHECK LINK

(WITHOUT AU, DK450L-EU)
(1) Check Link (2) Pin
Adjust the check links to control horizon-
tal sway of the implement.
Adjustment of
Attachment
chain length
Plow and
Loosen the chain for an
harrow
attachment to sway later-
ally by 50 to 60 mm.
(1.97 to 2.36in.)
Rotavator,
mower,
Fasten lightly
hayrack and
cultivator

TIRES

615O527A
(A) Insuffient
(C) Excessive
Though the tire pressure is factory-set
to the prescribed level, it naturally drops
slowly in the course of time. Thus, check
it everyday and inflate as necessary.
OPERATING 5-21
615O528A
(B) Standard