BWI Eagle AIR-EAGLE XLT Product Information Bulletin

AIR-EAGLE
900 MHz RF Transmitter
MODEL 44-10100-120I-AC
DESCRIPTION
The A -E XLT TX s an R.F. transmitter capable of sending a
IR AGLE I
single 120VAC input command to an Air-Eagle XLT Receiver located
up to 2500 feet away. Any number of transmitters and receivers can be
combined to create a medium range radio frequency system that
operates hazardous or hard-to-reach electrical apparatus from safe,
convenient locations. Seven user-selectable frequencies allow multiple
systems to operate simultaneously in the same area without
interference.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
DISCONNECT AC Power from all equipment before installation.
1. Mount the A -E XLT T
IR AGLE
2. Install wiring to input terminal strip
3. Install antenna. The unit has an antenna connector located on the
right side on the enclosure. Attach the supplied portable antenna to
this connector.
4. Connect AC power to the proper terminals in your control circuit.
TERMINAL STRIP WIRING
TER 3
TER 2
DRY CONTACT
RELAY OUTPUT
INPUT
1 120VAC N 1 Not Used
2 120VAC H 2 Not Used
3 Not Used
GENERAL OPERATION
When 120VAC appears on the input the unit transmits to energize relay 1
(or another relay as selected by the channel code transmitted) in any
receiver within transmit range. The signal transmits continuously as long
as the voltage is present and ceases when voltage is removed.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
® XLT
MCQ-XB900HP
1846A-XB900HP
in a convenient location.
RANSMITTER
TER 1
AC/DC POWER INPUT
1 120VAC (Neutral)
2 120VAC (Hot)
3 Ground
PRODUCT INFORMATION
BULLETIN
Dimensions (with mounting plate) 7.07L x 3.57W x 1.62H
CONTROLS AND INDICATORS
Power – LED1
Illuminates green when unit is powered
TX – LED2
Illuminates red when unit is transmitting
Relay – LED3
Not used on this model
RF module that sends data to the remote
RF1
receiver
Seven dip switches for selecting options and
SEL1
network frequency
TER3 120VAC input
TER2 Relay output
TER1 Power Input