AIR-EAGLE
900 MHz RF Transmitter
MODEL 441AN-1000-120VAC
DESCRIPTION
The A
-E
XLT,
441AN-1000-120VAC
IR
AGLE
MODEL
capable of sending two 4-20mA or 0-5VDC inputs to a remote receiver.
Transmitters and receiver can be combined in any quantity to create a
long-range radio frequency system that monitors electrical apparatus
from safe, convenient locations of up to 2500 feet away (or longer with
optional antennas). This unit is user-programmable for up to eight
network frequencies to allow multiple systems to operate
simultaneously in the same area without interference.
INSTALLATION
Mount the A
-E
XLT TRANSMITTER in a convenient location
1.
IR
AGLE
2.
Install wiring to input terminal strip.
3.
Install antenna onto TNC connector on side of unit.
4.
Plug supplied AC wall plug adapter into 110VAC outlet.
INPUT OPTIONS & FREQUENCY SET-UP
This transmitter is factory set for 4-20mA input, 0.262 transmit speed, and
to operate on frequency #1. If you wish to change the default settings,
follow the instructions using the table below:
1) Remove power from unit
2) Remove top cover.
3) Select desired input options and/or frequency using table below.
4) Reattach cover and apply power.
5) Programming is now complete.
INPUT CONFIGURATION
SEL1
OPEN
SWITCH
NUMBER
SW1
4-20mA Input
Transmit Speed 0.262
SW2
Seconds
(default)
SW3 &4
Reserved for future use
FREQUENCY SET-UP
Network
Frequency
1
(default)
2
3
SEL1
(SW5-7)
4
5
6
7
8
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
s an RF transmitter
I
CLOSED
(default)
0-5VDC Input
Transmit Speed 0.131
Seconds
SW5
SW6
OPEN
OPEN
OPEN
CLOSED
OPEN
OPEN
OPEN
CLOSED
OPEN
CLOSED
CLOSED
OPEN
OPEN
OPEN
CLOSED
CLOSED
OPEN
CLOSED
OPEN
CLOSED
CLOSED
CLOSED
CLOSED
CLOSED
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
TERMINAL STRIP WIRING
1
2
PCB LAYOUT
SW7
BULLETIN
3
4
5
6
7
8
9
10