Banner DUO-TOUCH SG Manual page 2

!
Important
The Banner DUO-TOUCH SG Two-Hand-Control safety system provides a measure of protection for the operator against reaching
danger zones during hazardous situations by locating the control actuating devices in a specific position and monitoring the
actuating devices for specific conditions.
In Europe, the functions that the Banner DUO-TOUCH SG Two-Hand-Control safety system is in tend ed to perform are regulated by
the CEN (European Committee for Standardisation) and the CENELEC (European Committee for Electrotechnical Standardisation).
Whether or not any particular DUO-TOUCH SG Two-Hand-Control system installation meets all applicable European and inter-
national requirements depends upon factors that are beyond the control of Ban ner En gi neer ing Corp. These factors include the
specific ways the safety module is applied, installed, wired, operated, and maintained.
Banner Engineering Corp. has attempted to provide com plete ap pli ca tion, in stal la tion, op er a tion, and maintenance in struc tions. In
addition, we suggest that any questions regarding the use or installation of this two-hand-control safety system be directed to the
factory ap pli ca tions de part ment at the telephone numbers or address shown on the back page of this manual.
The user of this Two-Hand-Control safety system must ensure that all machine operators, main te nance personnel, electricians, and
supervisors are thoroughly familiar with and un der stand all in struc tions regarding the installation, main te nance, and use of this
system, and with the machinery upon which it is installed.
The user and any personnel involved with the installation and use of this safety system must be thoroughly familiar with all
applicable European and international standards. The standards, listed below, directly address the use of two-hand-control systems.
Banner Engineering Corp. makes no claim regarding a specific recommendation of any organisation, the accuracy or effectiveness
of any information provided, or the appropriateness of the provided information for a specific application.
The user has the responsibility to ensure that all local, national and international laws, rules, codes, and regulations relating to the
use of this two-hand-control system are satisfied. Extreme care is urged that all legal requirements are met and that all installation
and maintenance instructions contained in this manual are followed.
Directives and Standards
ISO 12100-1 (EN 292-1)
ISO 12100-2 (EN 292-2)
ISO 13851 (EN 574)
ISO 13849-1 (EN 954-1)
ISO 13855 (EN 999)
IEC/EN 60204-1
2
page
®
DUO-TOUCH
... read this page before proceeding!
"Safety of Machinery – Basic Concepts, General Principles for Design, Part 1: Basic
Terminology, Methodology"
"Safety of Machinery – Basic Concepts, General Principles for Design, Part 2: Technical
Principles and Specifications"
"Safety of Machinery – Two-Hand-Control Devices"
"Safety of Machinery – Safety-Related Parts of Control Systems, Part 1: General Principles for
Design"
"Safety of Machinery – The Positioning of Protective Equipment"
"Electrical Equipment of Machines: Part 1: General Requirements"
Also, request a type "C" standard for your specific machinery.
SG –
Two-Hand-Control Kits with STB Touch Buttons
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164