Table of Contents
Advertisement
Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Response Time
Input Requirements
Simultaneity Monitoring
Period
Status Indicators
Housing
Protection class (IEC-60529)
Mounting
Vibration Resistance
Operating Conditions
Dimensions
Safety Category
Certifications
12
page
®
DUO-TOUCH
DUO-TOUCH SG Safety Module Specifications
24V ac/dc ± 15% at 150 mA (with STBVR81 or other mechanical switches)
24V dc ± 15% at 150 mA (with STBVP6 buttons)
Protected against transient voltages and reverse polarity
Outputs (K1 and K2): two redundant (total of four) safety relay (force-guided) contacts (N.O.)
Contact ratings:
Maximum voltage: 250V ac or 250V dc
Maximum current: 6A ac or dc (resistive load)
Maximum power: 1500 VA, 150 watts
Mechanical life: 10.000.000 operations
Electrical life: 150.000 cycles (typically at 1,5 kVA switching power)
NOTE: Transient suppression is recommended when switching inductive loads. Install suppressors across load.
Never install suppressors across output contacts (see Warning on page 9).
AT-FM-10K output response time: 35 milliseconds
DUO-TOUCH SG Kit (AT-FM-10K interfaced with STB buttons) output response time: 55 milliseconds
Outputs from two-hand-controls must each be capable of switching 10 to 50 mA at 18 to 30V dc.
500 milliseconds
4 green LED indicators:
Power ON
Input 1 energised
Input 2 energised
Output
Polycarbonate
IP20
Mounts to standard 35 mm DIN rail track. Safety Module must be installed inside an enclosure rated IP54, or better.
10 to 55Hz at 0,35 mm displacement per IEC 68-2-6
Temperature: 0° to +50°C
Maximum Relative Humidity: 90% at +50°C (non-condensing)
Heat Dissipation Considerations: See page 6
See Figure 6
Category 4 per EN 954-1/ISO 13849-1; Type IIIC per EN 574/ISO 13851
Yes – see Figure 9 on page 16
SG –
Two-Hand-Control Kits with STB Touch Buttons
1 red LED indicator:
Fault
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Advertisement
Table of Contents
