Circuit Priming; Using The Machine For The Fi Rst Time Or After A Period Of Inactivity - Gaggia Baby Dose Series Operating Instructions Manual

ENGLISH

Circuit Priming

N.B.: Upon fi rst use, after dispensing steam or when the
water tank is empty, the machine's water circuit must
always be primed.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system.
Put an empty cup below the steam frother (8), turn the
steam knob (25) clockwise and press the hot water supply
button (4).
You will hear the noise of the enabled pump and after a few
seconds water will come down from steam rod (8).
When the cup is fi lled press the hot water supply button (4)
again and close the steam knob (25).
NOTE: The temperature ready-light (7) will automatically
fl ash as the machine boiler heats. After switching on
the machine for the fi rst coffee, wait 6 minutes until the
machine has fully heated up, while for all subsequent
coffees the machine will be ready to use.
Caution: Never operate pump without water
in machine as damage to the pump may occur.
Damage of pump run without water is not covered
by warranty.
Another feature of the machine is the "no-drip system",
eliminating most of dripping from brewing head (14).
After coffee brewing, however, a little dripping may occur due
to wet coffee grinds in the fi lter-holder.
Using the machine for the fi rst time or
after a period of inactivity
This simple operation ensures an optimum brewing and must
be performed:
- at fi rst start-up;
- when the machine remains inactive for a long time (more
than 2 weeks).
NOTE: Dispensed water must be emptied into an adequate
drain. It is not suitable for food use. If the container fi lls
up, stop dispensing water during the cycle and empty it
before resuming the operation.
A (Fig.02) - Rinse the tank and fi ll it again with fresh
drinking water.
B (Fig.03) - Place a container under the steam wand
(Pannarello). Open the knob (25) slowly by turning it
clockwise. Press the button for dispensing water (4); the
indicator light will start blinking.
C Dispense the whole water tank from the steam/hot water
wand. To stop dispensing, press the button for dispensing
water (4) once again and close the knob (25) by turning
it counter-clockwise.
D (Fig.02) - Fill the water tank with fresh drinking
water.
E Insert the fi lter holder into the brew unit from the bottom
(14) and turn it from left to right until it locks into place.
F Place a suitable container under the fi lter holder.
G Press the brew button (6) and dispense all the water in
the water tank. Once the tank is empty, stop dispensing
by pressing the brew button again (6). At the end, empty
the container.
H Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
I The machine is now ready to be used.
For further information on how to dispense hot water, please
refer to sections "How to brew a good Espresso
Coffee" and "Making Hot Water".
• 14 •