Installation; Preliminary Operations; Priming The Water Circuit - Gaggia GXI /01 Operating Instructions Manual

INSTALLATION

Preliminary Operations

• Remove the coff ee machine from the packaging and position it in
a suitable place.
Using the Machine for the First Time
• Remove the water tank from its seat, rinse
it and fi ll it with still drinking water. Do not
exceed the level (MAX) indicated on the
water tank. Put the water tank back in its
seat.
Hot water or any other liquid may damage the tank
and/or the machine. Do not turn on the machine
when the tank is empty: Make sure there is enough water
in the tank.
• Insert the plug into the socket on the back of the machine (see
Fig. A) and insert the plug of the other end of the cable into a wall
socket with suitable power voltage.
• (GXI/02) - Make sure the switch is on "/"
position; if this is not the case, turn it onto
that position.
• To switch on the machine, set the power
button ON/OFF (on the back of the machine)
to "I".
Note: Before starting the machine for the fi rst time
or if the water tank has been completely emptied,
prime the water circuit.

Priming the Water Circuit

GXI/01
• The " " button turns on and the "
button blinks..
• Place a cup under the dispensing spout.
• Press the "
When water is dispensed correctly, press the
" " button again to stop dispensing.
• 16 •
procedure to dispense an entire water tank. At the end of this
operation, fi ll the tank again with fresh drinking water.
Stand-by
To turn the machine on again simply press the " " button.
" It is possible to manually activate the stand-by function by pressing
the " " button.
" button.
the system.
GXI/02
• The " " button turns on and the "
and " " buttons blink.
• To prime the water circuit, place a container
below the steam wand.
• Turn the hot water / steam knob clockwise
to its limit stop.
When the " " button turns off , rotate the
switch counter-clockwise to set it back to its
former position.
Note (for all the machine models): After priming the
water circuit, it is recommended to use the same
The machine is designed for energy saving.
The machine automatically goes into stand-
by mode after 1 hour of inactivity.
When the machine is in standby mode, the
" " button blinks slowly, while the other
buttons are off .
Note (for all the machine models): When restarting
the machine, brew once without capsule to optimize
"