Table of Contents
Advertisement
I I n n s s t t a a l l l l i i n n g g F F u u e e l l P P i i c c k k u u p p T T u u b b e e
Plastic Tank
I I m m p p o o r r t t a a n n t t : : Safety precautions must be followed. Refer to F F u u e e l l S S y y s s t t e e m m C C o o m m p p o o n n e e n n t t I I n n s s t t a a l l l l a a t t i i o o n n H H a a z z a a r r d d s s located in
the S S a a f f e e t t y y P P r r e e c c a a u u t t i i o o n n s s section of this manual before proceeding.
E E P P A A C C O O N N F F O O R R M M A A N N C C E E : : The fuel tank must have a label on the fuel inlet (fill spout) stating " ULTRA-LOW-SULFUR FUEL
ONLY". Verify label is present. If not present, order label 93-1184 and install on tank.Reference 40 CFR 1039.104(e)/
1039.135
I I M M P P O O R R T T A A N N T T I I N N S S T T A A L L L L A A T T I I O O N N T T I I P P S S
•
BEFORE drilling any holes, check for internal baffles inside the tank.
•
PRIOR to installation, remove protective caps from ends of pickup tubes.
•
DO NOT apply any type of sealant material to the fuel pickup tube assembly. Doing so will result in plugged fuel
lines.
N N o o t t e e : : Use a magnet, grease or special hole saws/drills that will minimize debris from entering the fuel tank. Thoroughly
clean and flush the tank to remove any debris.
FOLLOW THE INSTALLATION INSTRUCTIONS INCLUDED WITH THE FUEL PICKUP TUBE
44
Figure 29. Typical Plastic Fuel Tank Installation Shown
1
1.
Return Fitting
2
2.
Supply Fitting
RCS1104-1
TK 56701-1-IM-EN
Advertisement
Table of Contents
