Related Manuals for Trane TTK 509 E
Summary of Contents for Trane TTK 509 E
- Page 1 Installation Manual Mini-Split System Condensing Units TTK Horizontal Air Discharge 9,000 to 36,000 BTU/h 50/60 Hz Models: TTK 509 E TTK 518 E TTK 512 E TTK 524 E TTK 530 E TTK 536 E SS-SVN03B-EN September 2003...
- Page 2 About this Unit Warranty General Information These TTK condensing units are assem- Congratulations on your choice of a Trane Warranty is based on the general terms bled, pressure tested, dehydrated, mini-split system. These systems have and conditions by country. The warranty is charged and run tested before shipment.
-
Page 3: Table Of Contents
Contents Model Description General Data General Unit Location and Preparation Line Connection Refrigerant Line Connection Connection using Flange Thread-Type Valve System Evacuation System Evacuation and Purge Service Valve Multi-Function - Liquid Line Electric Connections Electric Connection System Start-Up System checking before start-up Dimensional Data TTK 509E / TTK 512E TTK 518E / TTK 524E / TTK 530E / TTK 536E... -
Page 4: Model Description
Model Number T T K 0 9 E 5 Digit 1 - Brand Name Trane Mini-split Digit 2 - Functional Type Cooling Only Heat Pump Digit 3 - Quantity of Refrigerating Circuits 1 Refrigerating Circuit Digit 4 - Refrigerant and Connection Types... -
Page 5: General Data
WARNING! that avoid client satisfaction arise, 4. When the unit is mounted on a roof, contact your nearest Trane sales office be sure the roof will support the unit After unpacking the unit, inspect the or Trane. -
Page 6: Line Connection
Line Connections 4. Make the flange of the tube as Refrigerant Line Connections Connection of refrigerant perfect as possible. lines to unit using flange Flange thread-type connection: thread-type service valves 5. Apply refrigerant oil on coupling surfaces of the union of the valve 1. -
Page 7: System Evacuation
System Evacuation System Evacuation and Purge 7. Replace the register and valve caps 3. The system should be evacuated until to prevent leakages. the vacuum gauge shows a reading 1. The outdoor unit is supplied with of 350 microns (5.9 x 10 inHg). -
Page 8: Service Valve
Service Valve Multi-Function (Liquid Line) Field Installation of the Re- Step 6. Manually install the flare nut on Step 4. The new restrictor should be the liquid line tube and be sure to apply appropriately lubricated and have an o- strictor for Multi-Function the correct torque. -
Page 9: Electric Connections
Electric Connections Electric Connections 4. Install an exclusive overcurrent protection circuit-breaker for the 1. Important: do not allow electric outdoor unit. It can also be used for wires from the compressor casing system protection. to touch refrigerant tubes or the 5. -
Page 10: System Start-Up
System Start-Up 3. Check piping and connections for 5. Check that voltage is within System checking before refrigerant leaks. specified ratings, and check for start-up proper circuit-breaker/fuse sizes. 4. Check that the unit has a proper grounding. If there is no grounding at 6. -
Page 11: Dimensional Data
Dimensional Data Figure 7. Outline Dimensions - TTK 509 E - TTK 512 E 250 (9.8) 700 (27.6) WIRING IN 2 X 22 (0.86) 40 (1.6) SUCTION CONNECTION LIQUID CONNECTION 4 x 12 (0.5) 472 (18.6) 112 (4.4) 5° AIR FLOW... -
Page 12: Ttk 518E Ttk 524E Ttk 530E Ttk 536E
Dimensional Data Figure 8. Outline Dimensions - TTK 518E - TTK524E - TTK530E - TTK536E 330 (32.7) 830 (32.7) 72 (2.9) 27 (1.06) WIRING IN LIQUID CONNECTION SUCTION CONNECTION 554 (21.8) 126 (5.0) 4 x 12 (0.5) AIR FLOW Note: All dimensions are in mm ( inches) Table 4 - Dimensional Data Connection Sizes Weight... -
Page 13: Typical Wiring Diagram
Typical Wiring Diagram Figure 9. Wiring Diagram - TTK 509E / 512E / 518E / 524E / 530E / 536E 220-240V 1PH 50/60Hz SS-SVN03B-EN... -
Page 14: Wiring Interconnection
Wiring Interconnection Figure 10. Wiring Interconnection: MCW, “K” and “L” model, with condensing units TTK NOTES: 1) Single power supply point for both units. (indoor unit and outdoor unit) 208-230V 1PH 50/60 Hz Figure 11. Wiring Interconnection: MCW, “K” and “L” models, with condensing units TTK 208-230V 1PH 50/60 Hz NOTES:... - Page 15 Wiring Interconnection Figure 12. Wiring Interconnection: MCW, “A” model, with condensing units TTK NOTES: 1) Single power supply point for both units. (indoor unit and outdoor unit) 208-230V 1PH 50/60 Hz Figure 13. Wiring Interconnection: MCW, “A” model, with condensing units TTK 208-230V 1PH 50/60 Hz NOTES:...
- Page 16 Wiring Interconnection Figure 14 . Wiring Interconnection: MCX with condensing units TTK NOTES: 1) Single power supply point for both units. (indoor unit and outdoor unit) 208-230V 1PH 50/60 Hz Figure 15. Wiring Interconnection: MCX with condensing units TTK 208-230V 1PH 50/60 Hz NOTES: 1) Single power supply point for each unit.
- Page 17 Wiring Interconnection Figure 16. Wiring Interconnection: MCD with condensing units TTK NOTES: 1) Single power supply point for both units. (indoor unit and outdoor unit) 208-230V 1PH 50/60 Hz Figure 17. Wiring Interconnection: MCD with condensing units TTK NOTES: 1) Single power supply point for each unit. 208-230V 1PH 50/60 Hz (indoor unit and outdoor unit)
- Page 18 Stocking Location: Houston, TX www.trane.com Trane has a policy of continuous product and product data improvement and reserves the right to change For more information contact design and specifications without notice. Only qualified technicians should perform installation and servicing your local Trane office or of equipment referred to in this publication.
Need help?
Do you have a question about the TTK 509 E and is the answer not in the manual?
Questions and answers