Error Code Troubleshooting - Graco ProMix PD2K Repair Parts

Error Code Troubleshooting

System errors alert you of a problem and help
prevent off-ratio spraying. There are three types:
Advisory, Deviation, and Alarm.
NOTE: Dual Panel systems (AC0502, AC1002
and AC2002) have most of the same error codes,
but may apply to a specific Mix Unit. Refer to
the PD2K Dual Panel Operations, Automatic
System, manual for those specific error codes. See
Related Manuals, page 6
An Advisory records an event in the system, and will
clear itself after 60 seconds. The four-digit error code
will be followed by "-V".
A Deviation records an error in the system but does
not shut down the equipment. The deviation must be
acknowledged by the user. The four-digit error code
will be followed by "-D".
If an Alarm occurs, operation stops. The four-digit
error code will be followed by "-A".
If any of the three system error types occur:
• Alarm buzzer sounds (unless in silent mode).
• Alarm popup screen shows the active alarm code.
• Status bar on the Advanced Display Module shows
the active alarm code.
• Alarm is saved in the date/time stamped log.
332709D
.
NOTE: A Record saves relevant system events in the
background. These are informational only and can
be reviewed on the Events screen, which displays
the 200 most recent events, with date, time, and
description.
NOTE: When an error occurs be sure to determine
the code before resetting it. If you forget which code
occurred, the Errors screen displays the 200 most
recent errors, with date, time, and description.
NOTE: In some error codes listed below, a # symbol
is shown as the last digit. This symbol represents the
applicable pump number, which can vary. The unit's
display will show the applicable pump number as the
last digit in the code.
Troubleshooting
15