Battery Backup; Radio Operation - Hyundai RAC 201 PLL Instruction Manual

LOCATION OF CONTROL
1. POWER ON-OFF
2. DISPLAY
3. VOLUME + / AL1
4. VOLUME - / AL2
5. FM AERIAL
6. TUNING 5 / HR
7. TUNING 6 / MIN
8. SLEEP
9. SET
10. SNOOZE/DIMMER

BATTERY BACKUP

The clock, alarm and preset stations settings can be protected against AC power failure with
the batteries for a short period of time. If no backup batteries are installed or the power failure
is prolonged, you will need to set the clock again.
Battery handling and usage
Only adults should handle battery. Do not allow a child to use this apparatus unless the battery
cover is securely attached to the unit.
STANDBY MODE
Place the unit on a flat stable surface and plug the power cord into the mains socket.
The unit is in standby mode and "0:00" will flash on the display.
SETTING THE CLOCK
1) In standby mode, press and hold SET until the display flashes.
2) Repeatedly press HR to set the hours.
3) Repeatedly press MIN to set the minutes.
4) Press SET to confirm.
The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press POWER ON-OFF to switch the unit on and enters the radio mode.
● The radio frequency will briefly appear on the display and then return to clock time.

RADIO OPERATION

1) Press POWER ON-OFF to turn on the radio.
The default FM frequency or the last frequency you tune the radio
to will show on display.
The default FM radio frequency is 87.5 MHz.
2) Press BAND once to enter the AM radio mode.
The default AM radio frequency is 522 kHz.
3) Repeatedly press BAND to select the desired radio band.
4) Adjust the volume by repeatedly pressing VOLUME +/-.
5) Repeatedly press TUNING 5/6 to tune into the desired station.
Press and hold TUNING 5/6 for auto forward or backward radio station searching.
11. BAND (AM/FM selector)
12. MEM (Preset radio station)
13. BATTERY COVER
14. PROJECTION ON/OFF
15. PROJECTION LENS
16. Alarm 1 buzzer indicator
17. Alarm 1 radio indicator
18. Alarm 2 buzzer indicator
19. Alarm 2 radio indicator
ENG - 18