Voltage Display Module And Dc Head Installation - Keywish Hummer-Bot-1.0 Instruction Manual

3.1.9 Voltage display module and DC head installation

Figure 3.1.33 Shematic diagram of voltage display module and DC head installation
We need to use two power cables (the same as the wires used by the motor, one red and one black), and
connect the two wires to the DC power supply head. DC power supply head as shown in Figure 3.1.34.
You need to remove the rubber ring at the "1" mark to open the caser and solder the wire to +12V and GND,
as shown in Figure 3.19.3.
Figure 3.1.34 Shematic diagram of solder DC power supply head
28