Table of Contents
Advertisement
7- Vertical stabilizer
PC-6 Porter
6C
X
FUSELAGE
FUSELAGE
REAR VIEW
REAR VIEW
Mark the rudder where the end of rudder torque rod
meet the rudder.
Remove the vertical stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above(6C)
* WARNING: When removing any covering from the airframe,
please ensure that you secure the cut edge with CA or similar
cement. This will ensure the covering remain tight.
Cut away only
the covering
both side
A B
! Securely glue together If coming off during
fly, you lose control of your air plane.
5 5
Secure the torque rod
bearing using Thin CA
6D
Cut away the covering material
from over the precut rudder
torque rod mounting slot in rudder.
Thin CA glue
Advertisement
Table of Contents
