Connectors - IBM SurePOS 700 Series Hardware Service Manual

Figure 5. Front panel controls and indicators.
Note: Use of the front headphone jack overrides the rear line-out jack
A
B
C
D
E
F
G
H
I
J
K
L
M
Note:

Connectors

The SurePOS 700 Series offers a unique configuration for connecting POS I/O
devices. Most of the POS-specific I/O function is contained on a riser card that
connects into the system board.
The SurePOS models support RS-485 POS I/O (4694 family), powered USB I/O
(IBM SurePOS 700 family), and powered RS-232 I/O. A unique tailgate design,
which includes IBM SurePort adapters, provides different configurations of I/O that
you can later upgrade or change in the field. The rear I/O panels are attached to
the riser card.
Table 5 on page 12 provides a summary of the available I/O ports.
A
M
L
K J I
Power LED
LED 1, processor fan failure
LED 2, system board failure
LED 3, upper HDD failure
LED 4, lower HDD failure
LED 5, power supply failure
Uninterruptible power supply switch (only with wide footprint and
uninterruptible power supply installed; otherwise covered)
Uninterruptible power supply indicator (only with wide footprint and
uninterruptible power supply installed; otherwise covered)
System power switch
Recessed dump switch
Headphone jack (Models 743, C43, E43, 783, E83, 784, C84, and E84
only)
Information LED
Hard disk or optical drive activity LED
G and H are available only if you install the optional uninterruptible power
supply.
F
B C D E
Chapter 1. Introducing the SurePOS 700 models
H G
11