Aiphone IXG-2C7 Installation Manual

Installation Manual
Introduction
• Read this manual before installation and connection.
Read the "Setting Manual" and "Operation Manual". The manuals can be downloaded from our
homepage at "https://www.aiphone.net/support/software-document/" free of charge.
• After completing installation and connection, program the system according to the "Setting Manual".
The system cannot operate unless it is programmed.
• After performing installation, review with the customer how to operate system.
Perform installation and connection only after gaining sufficient understanding of the
system and this manual.
Literature information
The important information concerning correct operation and what you should observe is marked with
the following symbols.
Indicates that users may require caution (including warning / caution).
Alerts users to prohibited actions.
Restricts user actions / provides instructions.
Tips and additional information for operation.
Example of System Configuration
IXG-2C7 (-L) IXG-MK PC (third party)
PoE switch PoE switch
(third party) (third party)
LAN
PoE switch PoE switch PoE switch
(third party) (third party) (third party)
Network Camera
(third party)
IX-DV IX-MV7-HB
Status Indicator
Refer to "IXG-2C7(-L) Operation Manual" for additional indicators not listed below.
Status (pattern)
Blue
0.75 sec 0.75 sec
flashing
0.5 sec 4 sec
1 0.25 0.25 0.25 0.25
sec sec sec sec sec
Blue light
IXG-2C7, IXG-2C7-L
Part Names and Accessories
IXG-2C7, IXG-2C7-L
Front view
Hearing aid T-mode
compatibility symbol
(IXG-2C7-L only)
Speaker
Touchscreen LCD
Included accessories
Installation
Download
Manual ×1
guide ×1
(this manual)
IXG-DM7 (-HID)
Precautions
Warning
PoE switch
(third party)
Do not disassemble or modify the
station.
This may result in fire or electrical
shock.
PoE switch
Do not connect any terminals on
(third party)
the station directly to an AC
power line.
This may result in fire or electrical
shock.
IXGW-LC IXGW-GW
Caution
Do not install or connect the
station with the power on.
: Lit : Off
This may result in electrical shock or
malfunction.
Description
Booting
Make sure the wiring is correct
and there are no wiring shorts
Communication
before switching on the station.
failure
Firmware version This may result in fire or electrical
0.25
sec
updating shock.
Standby (Depends
on setting)
(Tenant Station)
(hearing aid-compatible)
Back view
Status indicator (Blue)
MAC address
Microphone
Option connector terminal
Speaker
microSD TM card slot LAN(PoE) port
Chinese RoHS Mounting Option
declaration
×1 bracket ×1 connector ×2
(IXG-2C7 only)
(attached to the station) (10 pin ×1, 4 pin ×1)
Negligence could result in death or serious injury.
Do not, under any circumstances,
open the station.
Voltage within some internal
components may cause electrical
shock.
Negligence could result in injury to people or damage to
property.
Install in a place where the station
will not get easily bumped.
This may result in injury.
Do not put your ear close to the
speaker when using the station.
May cause harm to the ear if a
sudden loud noise is emitted.
About microSD card
Choose a microSD card (sold separately) using the recommended specifications below (these are
referred to collectively as "microSD cards").
Supported storage
Standard
capacity
microSDHC memory 4 GB to 32 GB
cards
• A microSD card is not included with this station.
• Some microSD cards may not operate properly.
• If the card contains data other than video/audio files, it may not have enough space to record video/
audio recordings.
• The network camera may not be able to record video, depending on the size of the video.
• A maximum of 999 video/audio files can be saved. However, this may vary depending on the size of the
video/audio files and the capacity of the microSD card.
• Aiphone is not to be held responsible in any way for microSD cards.
Cable tie ×1
General Precautions
• Install low-voltage lines at least 30cm (12") away from high-voltage lines (AC100V - 240V), especially inverter
air conditioner wiring. This may result in interference or malfunction.
Notice
• The illustrations used in this manual may differ from the actual product.
• If the station is used in areas where there are business-use wireless devices such as a transceiver or mobile
phones, it may cause malfunction.
• If the station is installed in an area with an extremely strong electrical field, such as in the vicinity of a
broadcasting station, it may create interference and cause malfunction.
Precautions for mounting
• Installing the device in the following locations could cause malfunction:
- Locations under direct sunlight
- Locations near heating equipment
- Locations subject to liquid, iron filings, dust, oil, or chemicals
- Locations subject to moisture and humidity extremes
- Locations where the temperature is quite low
- Locations subject to steam or oil smoke
- Sulphurous environments
- Locations close to the sea or directly exposed to sea breeze
• If existing wiring is used, the device may not operate properly. In that case, it will be necessary to replace the
wiring.
• Do not use an impact driver to fasten screws. Doing so may cause damage to the device.
• Avoid installing the station in concave space of a wall to prevent disconnection of communication.
• This unit is designed for indoor use only. Do not install at outdoor location.
Issue Date Mar. 2020 FK2530 A P0320 RQ 60259
Format Speed class
FAT32 SD speed class 10