Table of Contents
Advertisement
On/Off Modes
LED Indicators
The top of the Kilo uses red and green LEDs to show its on/off status. It is also to be used as an
indicator for when the magnetic switch is used to turn the device on/off. This same LEDs are also
used during self-test failure.
Unit Status Indicators
Action: Turn On
Swipe Magnet back and forth across mag switch until LED is solid green
Action: Turn Off
Swipe magnet back and forth across mag switch until LED is solid red
Check Status
Swipe magnet once across mag switch (red is off, green is on)
Flashing 0.5 Hz
Self-test failure
after power-up,
beeping
Using the Magnet
The Kilo beacon is turned ON and OFF using an external magnet near
an internal magnetic reed switch, and operation can be identified by
viewing the LED through the top of the Kilo.
To turn the Kilo on, begin swiping the magnet slowly up and down
at the location of the reed switch. The reed switch is located along
the top of the cylindrical section of the Kilo.
Note:
If the initial color of the LED is Green after a single swipe, the
Kilo is already operational.
A flashing green LED indicates the device is in the process of
powering up. Continue to swipe the magnet until you see a solid green LED. A solid green LED
indicates that the device is powered and operational.
To turn the Kilo OFF, repeat the above procedure with the magnet and watch the LED change
from green to red. A red flashing LED indicates the device is powering down. Continue to swipe
the magnet until you see a solid red LED. A solid red LED indicates that the device is turned OFF.
At any time, the magnet can be placed against the location of the reed switch once to see which
mode the beacon is currently in. A red LED indicates the device is turned OFF. A green LED
indicates the device is turned ON.
It is important to wait for all LED's to turn off before initiating another action.
Cycling power for any reason, for example by using the switch to turn OFF/ON or by
removing battery power, will start the startup interval.
NOTE:
If after starting up, the red LED continuously flashes and/or beeping occurs for an
extended period of time, the device is experiencing a
orientation first, and if this does not remedy the situation, contact
Kilo User Manual Version 3.0
SELF-TEST
FAILURE. Check the battery
support@xeostech.com
12
Advertisement
Table of Contents
