Table of Contents
Advertisement
On/Off Modes
Using the Magnet
The Resilient beacon is turned ON and OFF using an external magnet
near an internal magnetic reed switch, and operation can be
identified by viewing the LED through the top of the Resilient.
To turn the Resilient ON, begin swiping the magnet slowly up and
down at the location of the reed switch. The reed switch is located
directly behind the Swipe On/Off Here label.
To turn the Resilient OFF, repeat the above procedure with the magnet and watch the LED change
from green to red. A red flashing LED indicates the device is powering down; continue to swipe
the magnet until you see a solid red LED. A solid red LED indicates that the device is turned OFF.
At any time, the magnet can be placed against the location of the reed switch once to see which
mode the beacon is currently in. A red LED indicates the device is turned OFF. A green LED
indicates the device is turned ON.
If the batteries are low, or if some of the batteries have been inserted incorrectly, the Resilient
will sound a quick intermittent beep and flash the red LED at the top for 5 minutes, or until the
batteries have been corrected or replaced. If this behavior persists even if the batteries are full
and oriented correctly, this indicates a
this occurs.
It is important to let all LEDs stop illuminating before initiating another action.
Cycling power for any reason, for example by using the switch to turn OFF/ON or by
removing battery power, will initiate the Startup Mode.
LED Indicators
The top of the Resilient (and bottom of ROBY) use red and green LEDs to show their on/off status.
It is also to be used as an indicator for when the magnetic switch is used to turn the device on/off.
This same LEDs are also used during self-test failure or Bluetooth connection.
Unit Status Indicators
Action: Turn On
Swipe Magnet back and forth across topside until LED is solid green
Action: Turn Off
Swipe magnet back and forth across topside until LED is solid red
Check Status
Swipe magnet once across topside (red is off, green is on)
Other Indicators
Flashing 4 Hz on
Device powering up, performing self-test
power-up
Flashing 0.5 Hz
Self-test failure
after power-up
Flashing 4 Hz on
Device acknowledging Bluetooth is connected
Bluetooth
Connection
Resilient User Manual Version 2.0
SELF-TEST
FAILURE. Contact
support@xeostech.com
if
11
Advertisement
Table of Contents
