Table of Contents
Advertisement
sufficiently, or watch circle functionality is turned off. The Kilo will also continue to display its
distance from the centre of the programmed circle.
Reset
The Reset command does a full software reset of the Kilo. This will effectively power the beacon
OFF and then ON. The Kilo's timers and settings will not be reset but watch circle specifics will
be erased. This command should only be used on the advice of Xeos Technologies Inc. The reset
command is as follows:
$resetnow
Restore Factory Defaults
To reset the device back to the settings it was originally programmed with on manufacture,
send the following command:
$factorydefaults
The device will reconfigure, and reset on receiving this command.
Kilo User Manual Version 3.0
22
Advertisement
Table of Contents
